Mazda MX-30 Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
After Mazda update AM001A is uploaded it is possible to switch of the fake engine sound with below steps.

To deactivate the "Engine Sound":
1. Switch ON Power 2x without pressing brake pedal to READY OFF mode
2. Move / check the gear selector to the P position.
3. Hold down the pedals and perform the following steps within 10 seconds ! (the pedals should be depressed throughout the process until step 5).
4. Press the plus button on the Right steering wheel paddle (+) five times
5. Press the minus button on the Left steering paddle (-) five times.
6. Release the drive and break paddles.
7. Shift OFF the Power.

To reactivate the "Engine Sound" once deactivated just repeat the above steps again.
 

· Registered
Joined
·
789 Posts
Is that the same as this one?

 

· Registered
Joined
·
81 Posts
Discussion Starter · #3 ·
Is that the same as this one?

Yes. It is.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top